DIY Plumbing

Leaking pipes, no matter how big or small can
create extreme changes on your water bills, negative
changes to be specific. However, fixing a minor leak is
actually easy and is something that you can manage to
do without calling a plumber. Here are some ways you can repair pipe leaks yourself.Fixing Leaks Through Tape

This is considered the easiest and cheapest way
to fix small pipe leaks. The only
material you would need is electrical or duct tape.
The basic principle here is that you cover the
leak using the tape. To effectively stop the leak, you
should start wrapping the tape before the leak itself
on your water pipe. Wrap in a diagonal manner around
the pipe until you have covered the entire leaking
area and a small portion extending before and after

Fixing Leaks By Epoxy

This method is best used if the leak is
situated at pipe fittings and joints. You can get
epoxy from your local hardware store. First off, you
should cut off the water supply. Then you need to
drain all the water from the pipes. Water purging can
be done by letting the faucet run, until no more water
comes out.

After purging the water, dry out the pipes and clean
it using steel wool. Make sure that the pipes are dry
and clean, since applying epoxy on a wet pipe can give
unpleasant results. If you are sure, then apply the
epoxy and let it dry. Refer to the epoxy’s packaging
on how long you should let it stand to dry up. Avoid
using the pipe line if the epoxy is still wet.

Fix Leaks Through A Pipe Clamp

You can use pipe clamp to fix your leaks. However, you
should buy a clamp that has the right size to fit your
leaking pipe. Once you have purchased a clamp, clean
out your pipe. Be careful in cleaning it, and make
sure that you do this well. Wrap your pipe in a rubber
pad which should be placed over the area where the
leak is.

When you have the pad in place, put the pipe clamp
over it and screw the clamp securely. If you have
somewhat moderate leaks, you can also use this method
to stop them.

Fixing Leaks Through Hose Clamps

Using a hose clamp is kind of similar to using a pipe
clamp. However, this is to be only used on smaller
leaks. You can start by wrapping the pipe with a
rubber pad. Once the pad is placed over the leaking
area, put one or two hose clamps over it and tighten
the pad by securely screwing it.

Fixing Leaks Through C-Clamps and Blocks

If your pipe is of a small size, then you can make use
of a small sized c-clamp to patch it. Start by placing
a rubber pad directly on top of the leak. After that,
put a small wooden strip or block on top of it. Get
the c-clamp and place it over the fixture to hold
everything on place. You use the blocks as protection
for the pipe from the pressure given by the c-clamp.

Fixing Leaks Using Tin Can Clamps

Here, what you would need is a tin can. Start off by
cutting the ends off the can and cutting it up one
side. Get the half of the can and bend its ends so
that they are flat and could meet. This is like a
homemade pipe clamp.

Get a rubber pad and place it over your leak. Above
the rubber pad, place your homemade clamp. A c-clamp
and wooden blocks can also be used to tighten the

For more articles go to